crwdns2915892:0crwdne2915892:0
This replacement is fairly straight forward. The only tool you will need is a #00 Phillips screwdriver and/or an extra long #00 Phillips screwdriver. Optionally, you could use a nylon spudger to help pry open the camera shell.
crwdns2942213:0crwdne2942213:0
-
-
Remove the six 4.5 mm #00 Phillips screws from the bottom, left, and right sides.
-
-
-
Use a spudger to remove the film slot guard on the top of the camera.
-
Remove the one 4.5 mm #00 Phillips screw under the slot guard.
-
-
-
-
Press the release tab on the back of the camera to open the film compartment.
-
Remove the film cartridge within this compartment.
-
-
-
Press the battery cover in and down to remove it.
-
Remove any batteries within.
-
-
-
Use a plastic opening tool to help pry the front and back shells apart.
-
With the camera facing down, remove only the back shell.
-
-
-
Carefully peel the front side of the shell away.
-
Using a set of tweezers, detach the spring from the body. The spring will retract into the black and gray ring on the front shell.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.