crwdns2915892:0crwdne2915892:0
Learn how to replace the speaker in a Fujifilm FinePix XP80 camera.
Please note: this guide requires soldering. For more information, see the Soldering Guide.
crwdns2942213:0crwdne2942213:0
-
-
Open the side panel which houses the battery compartment. Press the center button down and twist the dial.
-
-
-
Release the battery from its secured position by pulling the orange tab back. The battery can then be removed from its compartment.
-
-
-
Using a Phillips PH000 bit, remove the five 2mm screws on the bottom of the camera.
-
-
-
Using a H1.3 hex head bit, remove the two 2mm screws from the top of the camera.
-
-
-
Using a H1.3 hex head bit, remove the two 2mm screws on the side of the camera.
-
-
-
Using a plastic opening tool, gently pry up the edge of the button case, located at the top of the camera, until it unclips.
-
-
-
Gently pry the side area of the case apart.
-
-
-
-
Continue using the opening tool on the bottom of the camera to gently pry the case apart.
-
-
-
Use the plastic opening tool to carefully pry the yellow front panel completely away from the camera.
-
Use your hands to take off the yellow back panel.
-
-
-
Using the H1.3 hex head bit, remove the four screws on the front of the camera.
-
-
-
Using the H1.3 hex head bit, remove the screw on the back of the camera.
-
-
-
Open the battery compartment on the side of the camera.
-
Using your plastic opening tool, carefully pry the two clips apart as indicated in the photo.
-
-
-
Unclip the front interior panel from the top, bottom and side of the camera.
-
-
-
Gently open the camera, noting the presence of two orange tapes along one side that connect the motherboard to the LCD screen.
-
Open the camera like a book and lay both sides flat next to one another, leaving the orange tapes connected.
-
-
-
Carefully remove the black sticker covering the motherboard.
-
-
-
Using a PH000 Phillips bit, remove the four screws shown.
-
-
-
Using a plastic opening tool, carefully remove the lens housing to the left of the motherboard.
-
-
-
Peel back the sticker on the side of the motherboard.
-
Using a PH000 Phillips bit, remove the screw.
-
-
-
Using a PH000 Phillips bit, remove the screw shown.
-
Unclip the three ribbon cables that are still attached to the motherboard.
-
Use the plastic opening tool to gently pry the motherboard loose.
-
Move the motherboard aside slightly to reveal the speaker, which is connected to the motherboard by red and black wires.
-
-
-
Lift the motherboard out of the way, being careful of the speaker wires.
-
Carefully pry the speaker out of its slot in the case.
-
-
-
To remove the speaker from the motherboard, desolder its connection.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
USF Tampa, Team 1-3, Cagle Fall 2016 crwdns2935289:0USF Tampa, Team 1-3, Cagle Fall 2016crwdne2935289:0
USFT-CAGLE-F16S1G3
crwdns2931471:05crwdne2931471:0
crwdns2935297:014crwdne2935297:0
