crwdns2915892:0crwdne2915892:0
In this replacement guide, we will be showing the consumer how to correctly replace the inner speaker of the device.
crwdns2942213:0crwdne2942213:0
-
-
Begin by unscrewing the four 10.72mm corner screws using the Hex 2.0 screwdriver.
-
Using the Hex 1.5 screwdriver, remove the remaining six 5.79mm screws on the front of the speaker.
-
Pull the front part of shell away from the back part of shell.
-
-
-
Change to the Hex 1.3 head. Remove all 4-5.57mm screws on both speaker covers.
-
Pull on the speaker covers to remove them.
-
Rotate to side the speaker that has the charging port. Remove the 4-5.57mm screws of the facing you.
-
Rotate the speaker 180 degrees and then remove 4-5.57 screws on the side speaker that has the power/bluetooth buttons
-
-
-
-
Have back of speaker facing you, remove 5-12.70mm screws using 1/16 flat head screwdriver.
-
Using the plastic opening tool you will be able to wedge back face of speaker off.
-
-
-
The circuit board will be revealed, you will notice the various individual speaker connections to the circuit board.
-
Remove black "clip" from the circuit board. Using the T9 screwdriver head remove the 2-7.20mm screws, and remove the speaker from the body of the device
-
-
-
At this point, the next step would be to replace the speaker.
-
-
-
Undo the clips that are now exposed inside of the speaker. The colors of these clips are white, red, blue.
-
Once the clips are undone, you can freely remove and replace the corresponding speaker within the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team 1-2, Mathisen Winter 2017 crwdns2935289:0Eastern Washington University, Team 1-2, Mathisen Winter 2017crwdne2935289:0
EWU-MATHISEN-W17S1G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
