crwdns2942213:0crwdne2942213:0
-
-
Flip device upside down and remove the 4 foam pads at each corner.
-
-
-
Remove the 4 screws using a Philips Screwdriver.
-
-
-
Gently lift the case off of the body and set down in a safe place.
-
-
-
-
Unscrew the 5 screws in the base circuit board.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use the tweezers to slightly lift the circuit board, allowing the cylindrical alarm piece to slide out.
-
-
-
If they are not attached, you may re-solder it together. If they are attached, that means it is a faulty alarm and should replace it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0