crwdns2915892:0crwdne2915892:0
If the speaker is dead or blown, install a new one.
crwdns2942213:0crwdne2942213:0
-
-
Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.
-
-
-
Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
-
-
-
Once the top is separated, use your hand to remove the back panel from the unit.
-
-
-
-
Using tape or a post-it, label the input and output wires on the reverb. Remove these wires from the box.
-
-
-
Remove the two female connection terminals from the speaker terminals.
-
-
-
Use a Philips #1 screwdriver to remove the four 21.9 mm Phillips screws from the perimeter of the speaker.
-
To install the new speaker, follow the instructions given in reverse.
To install the new speaker, follow the instructions given in reverse.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0