crwdns2915892:0crwdne2915892:0
Use this guide to replace a broken rear-facing camera in your Fairphone.
crwdns2942213:0crwdne2942213:0
-
-
With the indentation as leverage, use your fingernail to pry the bottom portion of the back cover from the phone.
-
-
-
Slide the back cover down and remove it from the phone.
-
-
-
Use a fingernail in this indentation to push the battery toward the top of the phone
-
Pull the battery out away from the phone.
-
-
-
Remove the battery from your Fairphone.
-
-
-
Use your finger to slide the SIM card straight down out of its tray.
-
Remove the SIM card from your Fairphone.
-
-
-
If you have a microSD card, use your finger to slide it straight out of its slot.
-
Remove the microSD card from your phone.
-
-
-
Remove the five 3.9 mm Phillips #000 screws securing the midframe to the display assembly.
-
-
-
-
Use an opening pick to carefully pry the midframe away from the display assembly.
-
Start just below the volume rocker and work your way down toward the bottom of the phone, freeing the plastic clips along the side.
-
-
-
Carefully round the corner, separating the midframe from the display assembly.
-
-
-
Run the opening pick and pry along the top seam.
-
-
-
Separate any remaining clips and remove the midframe from the phone.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Use tweezers to remove the volume rocker and power buttons from the display assembly.
-
-
-
Use the flat end of a spudger to disconnect the antenna cable connector.
-
-
-
Use tweezers to remove the adhesive foam tape from the top of the digitizer cable ZIF socket.
-
-
-
Use the tip of a spudger to flip open the tab on the digitizer ZIF connector.
-
Use tweezers to pull the digitizer cable away from its socket on the motherboard.
-
-
-
Remove the three 2.5 mm Phillips #000 screws securing the motherboard to the display assembly.
-
-
-
Gently lift the top end of the motherboard up to expose the display data cable.
-
-
-
Use the tip of a spudger to disconnect the display data cable from the back of the motherboard.
-
-
-
Remove the motherboard from the display assembly.
-
-
-
Use the flat end of a spudger to disconnect the rear-facing camera cable connector from its socket on the motherboard.
-
Remove the rear facing camera from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:08crwdne2935229:0
