crwdns2915892:0crwdne2915892:0
If you determine that your vacuum brush roll will not turn and produces a burning smell, this guide will help you to replace the brush roll.
crwdns2942213:0crwdne2942213:0
-
-
Step on the grey release button located between the two back wheels to lower the handle flat to the floor.
-
-
-
Using a Phillips #2 screwdriver, remove the four screws from each corner of the brush roll cover.
-
-
-
-
Remove the brush cover from the vacuum base, by pulling straight up.
-
-
-
Firmly press upwards from below the brush roll on the side opposite the belt.
-
-
-
After one end is displaced, remove the other side by pressing firmly upwards from below the the brush roll.
-
-
-
Once the brush roll is displaced from the base, detach the belt from the brush roll in order to clean the brush roll.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:06crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Clemson, Team 2-2, Benson Fall 2014 crwdns2935289:0Clemson, Team 2-2, Benson Fall 2014crwdne2935289:0
CLEM-BENSON-F14S2G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:018crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Brush roll replacement is a no brainer. It is the brush roll assembly that turns the brush that I need to fix. Cannot determine what tool to use as it doesn't come off using a regular screwdriver and eureka won't tell me what to ese.
