crwdns2942213:0crwdne2942213:0
-
-
Press and hold down the black button below the handle while pulling the pole out.
-
-
-
Press the black separator switch to separate the top and bottom halves of the vacuum.
-
-
-
-
Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.
-
Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.
-
-
-
If the external switch is slightly misaligned as shown, realign it with the internal switch.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.