crwdns2915892:0crwdne2915892:0
If the alarm on your Equity Alarm Clock 13014 is not going off, use this guide to replace the alarm switch.
The alarm switch is a small lever that is flipped, at the set time of the alarm, to activate an internal circuit which in response triggers the alarm to sound. A faulty alarm switch will not activate the internal circuit therefore, never triggering the sound.
Step 5 requires knowledge of basic soldering to detach a wire.
Here is a helpful video on basic soldering: How To Solder and Desolder Connections
crwdns2942213:0crwdne2942213:0
-
-
Remove the battery door using your finger nail or an opening tool.
-
-
-
Use a Phillips #1 screwdriver to remove the 3 screws on the back cover.
-
-
-
-
Remove the back cover gently.
-
-
-
Use a Phillips #1 screwdriver to remove the small screw located above the alarm switch.
-
Remove the small screw located below the alarm switch as well.
-
-
-
Place the end of the soldering iron on the end of the wire connected to the copper cylinder to detach the wire.
-
To replace the alarm switch, attach one end of new alarm switch wire to the copper cylinder.
-
Use a Phillips #1 screwdriver to reinstall the switch screws.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team 1-6, Carnegie Fall 2014 crwdns2935289:0Eastern Washington University, Team 1-6, Carnegie Fall 2014crwdne2935289:0
EWU-CARNEGIE-F14S1G6
crwdns2931471:06crwdne2931471:0
crwdns2935297:06crwdne2935297:0
