crwdns2915892:0crwdne2915892:0
This is a replacement guide for the power supply for the Epson PowerLite 822 Plus. Model number EMP-822H. When the power supply is not working as it should that is when the projector will not show a status or reaction when turned on. This guide will show you how to remove and replace the current power supply in your projector.
crwdns2942213:0crwdne2942213:0
-
-
Flip the projector over.
-
Remove all 8 screws on the bottom of the projector.
-
-
-
Now, flip the projector back over and pry the top of it open revealing the inside of the projector.
-
-
-
Use the spudger to disconnect it from the motherboard.
-
-
-
Using your finger gently move back and forth the JST cable that connects the top to the motherboard.
-
Now completely take off the top of the projector.
-
-
-
Remove the 3 screws that secure the motherboard in place.
-
-
-
Gently move back and forth the 11 JST connectors until they come out.
-
-
-
-
With the spudger lift the red plastic tabs from their connectors.
-
-
-
Lift the motherboard and disconnect the JST connector underneath.
-
-
-
Now, the motherboard is completely removed from the projector and you are ready to replace it.
-
-
-
Unscrew the four 6mm screws that hold together the fan bracket.
-
-
-
Unscrew the four 6mm screws that secure the projector.
-
-
-
Remove the power plug attached to the bracket which kept the fan in place by rocking it back and forth and gently pull up when it is loose.
-
-
-
Remove the rest of the bracket which helped keep the exhaust fan in place.
-
-
-
Use a Phillips #2 screwdriver to remove the two 6 mm screws that secure the wire guide.
-
-
-
Gently lift up the wire guide to remove the wires.
-
Use your fingers to firmly press on the sides of the power plug and lift it upward.
-
You will now be able to remove and replace the power supply.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.