crwdns2915892:0crwdne2915892:0
Use this guide to replace an old or damaged lamp inside of the Epson Powerlite 460 projector.
The lamp creates light that produces vivid image displays from the projector. When the lamp exceeds its lifespan or is damaged, the image display can be dim or distorted. In some cases, no image display will appear at all.
Make sure to review the troubleshooting guide; sometimes a distorted image is caused by another issue and does not require the lamp's replacement.
When you are disposing of your old lamp, make sure to check your state’s requirements for disposal of the lamp since it does contain mercury.
Once you have installed the new lamp, remember to reset the lamp timer in the menu.
crwdns2942213:0crwdne2942213:0
-
-
Remove the 13.3 mm lamp cover screw using a Phillips #2 screwdriver.
-
Slide the cover off.
-
-
-
-
Loosen the two captive lamp screws using a Phillips #2 screwdriver.
-
-
-
Grab the lamp by the silver handle and pull out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Eastern Washington University, Team 1-1, Carnegie Spring 2022 crwdns2935289:0Eastern Washington University, Team 1-1, Carnegie Spring 2022crwdne2935289:0
EWU-CARNEGIE-S22S1G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:05crwdne2935297:0
