Epson PictureMate Pal PM 200 Printer Top Plate Replacement

crwdns2915892:0crwdne2915892:0

The top plate includes the buttons and screen for operating the device. The plate will need to be replaced in the event of cracking or buttons not operating due to device lid. The top plate may also need to be removed to access any components underneath it that need to be replaced.

Before using this guide, inspect the top plate for any cracks or wearing, as these will need to be treated carefully while handling the plate. Additionally, the top lid can easily be removed by lifting the lid up and gently pulling. This guide does not utilize this feature, but should be considered in case the lid is in the way.

crwdns2942213:0crwdne2942213:0

crwdns2931653:01crwdne2931653:0 Printer Top Plate

Epson PictureMate Pal PM 200 Printer Top Plate Replacement, Printer Top Plate: crwdns2935265:01crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Epson PictureMate Pal PM 200 Printer Top Plate Replacement, Printer Top Plate: crwdns2935265:01crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Epson PictureMate Pal PM 200 Printer Top Plate Replacement, Printer Top Plate: crwdns2935265:01crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Be certain that device is powered off and unplugged as to not damage any of the internal components before beginning.
Power off device and use a metal spudger to remove each of the two caps over the screws that hold the top plate to the device.

crwdns2913378:0crwdne2913378:0

crwdns2931653:02crwdne2931653:0

Epson PictureMate Pal PM 200 Printer Top Plate Replacement: crwdns2935265:02crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

Remove the two 6 mm Phillips screws.

crwdns2913378:0crwdne2913378:0

crwdns2931653:03crwdne2931653:0

Epson PictureMate Pal PM 200 Printer Top Plate Replacement: crwdns2935265:03crwdnd2935265:01crwdnd2935265:02crwdne2935265:0

Epson PictureMate Pal PM 200 Printer Top Plate Replacement: crwdns2935265:03crwdnd2935265:02crwdnd2935265:02crwdne2935265:0

Gently lift the lid and turn it to face the daughterboard underneath.
Gently pull the no-fuss ribbon cable out from its connector.
The other end of the ribbon cable is still in the device's motherboard. Only remove the end connected to the daughterboard unless stated in a later step in order to not lose it due to unnecessary removal.