crwdns2915892:0crwdne2915892:0
If no wireless functions are responding, the projector’s wireless connection board may be broken. This component is located inside the projector above the supply power box which is located near the projector lens.
crwdns2942213:0crwdne2942213:0
-
-
Orient the Epson Home Cinema 2150 so that the large indented panel faces your direction.
-
Unscrew the single 6mm Phillips#2 holding screw from the access panel.
-
Slide the panel horizontally, then lift up to remove the access panel.
-
-
-
Loosen and remove the two screws holding the lamp.
-
Remove two 9 mm Phillips #2 screws.
-
-
-
Using four fingers, pull upwards on the lamp's plastic casing.
-
-
-
Remove the air filter cover. Grip the piece with two fingers above and below at the center.
-
Grab the air filter from the protruding tab and pull the filter out.
-
-
-
From the back of the projector remove three 6 mm Phillips #1 screws.
-
-
-
-
From the device's underside, remove eleven 9.5 mm Phillips #1 screws.
-
Remove two 6 mm Phillips #1 screws.
-
Pull off remaining plastic molding.
-
-
-
From the lamp access slot, remove four 9.5 mm Philips #1 screws
-
-
-
From the filter slot, unscrew two 9.5 mm #1 screws.
-
-
-
Partially lift the top portion of the device housing.
-
-
-
Disconnect the ribbon cable from the motherboard.
-
-
-
Remove three 5 mm Phillips #1 screws.
-
-
-
Press on the metal connector and firmly pull on the remaining ribbon cable.
-
-
-
Pull the clips on the case with two fingers on opposite ends and remove the case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
CSU Los Angeles, Team 6-2, Adachi Fall 2022 crwdns2935289:0CSU Los Angeles, Team 6-2, Adachi Fall 2022crwdne2935289:0
CSULA-ADACHI-F22S6G2
crwdns2931471:04crwdne2931471:0
crwdns2935297:05crwdne2935297:0
