crwdns2915892:0crwdne2915892:0
The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.
crwdns2942213:0crwdne2942213:0
-
-
Remove all the brushes from the Deebot.
-
-
-
Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.
-
-
-
-
Using the two white straps on the sides of the battery, gently remove the battery.
-
-
-
Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.
-
-
-
Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper.
-
-
-
Remove the black strip on the bottom of the bumper.
-
-
-
Carefully lift up the bumper untill it pops out of place.
-
-
-
Disconnect the two cables connecting the bumper to the body of the Deebot.
-
Remove the front bumper from the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020 crwdns2935289:0Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020crwdne2935289:0
ERAU-RAUCH-S20S6G1
crwdns2931471:03crwdne2931471:0
crwdns2935297:017crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Where may I buy the front bumper assembly? I'm trying to replace one for a deebot 901 but the mfg tells me they don't see the part directly.
