crwdns2915892:0crwdne2915892:0
Use this guide to replace the carburetor in your Echo Chain Saw CS-4910 (2020).
Although it's not necessary to remove the guide bar, it's highly recommended you do so to minimize any damage to the chain and to yourself.
crwdns2942213:0crwdne2942213:0
-
-
Make sure you have the ignition switch turned off before starting your repair.
-
-
-
Use your fingers to loosen the air filter cover knob.
-
-
-
Remove the air filter cover.
-
-
-
Remove the air filter
-
-
-
Use your fingers to pull up and disconnect the spark plug boot.
-
-
-
Use a 13 mm wrench to loosen and remove the two nuts securing the sprocket guard.
-
-
-
-
Pull the sprocket guard straight off its two pegs and remove it.
-
-
-
Pull the saw chain away from the tip of the guide bar to unclip it.
-
-
-
Push the guide bar towards the back of the device to unclip the rest of the saw chain.
-
Pull the guide bar away from the device to separate the saw chain from the clutch drum.
-
Remove the guide bar and the saw chain.
-
-
-
Use a flathead screwdriver, or a 3 mm hex key, to remove the three 18 mm screws securing the engine cover.
-
-
-
Pull the engine cover straight up off the engine.
-
Remove the engine cover.
-
-
-
Use your fingers to pull the top-most fuel pipe out of the carburetor.
-
-
-
Lift the choke rod out of its recess in the chassis.
-
Twist the rod counter-clockwise to disconnect it from the carburetor.
-
Remove the choke rod.
-
-
-
Remove the four screws securing the carburetor and the air filter adapter:
-
Use a 3 mm hex key to remove the two 20 mm-long screws.
-
Use a 4 mm hex key to remove the two 53 mm-long screws.
-
-
-
Pull the air filter adapter straight off the carburetor and remove it.
-
-
-
With the carburetor's choke valve facing you, tilt the carburetor up and to the left to expose the right-most fuel pipe.
-
-
-
Use your fingers to disconnect the right-most fuel pipe.
-
-
-
Lift the carburetor straight off the throttle rod and remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
