crwdns2915892:0crwdne2915892:0
This guide shows how to remove and replace the clutch assembly in an Echo SRM-2620U Brushcutter.
crwdns2942213:0crwdne2942213:0
-
-
Grip the plastic housing at the end of the spark plug wire and pull firmly to disconnect it.
-
-
-
Unclip the throttle cable routing clip from the main shaft.
-
-
-
Grip both ends of one of the control cable bullet connectors and pull to disconnect it.
-
Repeat to disconnect the second control cable connector.
-
-
-
Use a T30 Torx driver to remove the two screws securing the muffler cover.
-
-
-
Lift the muffler cover up and pivot it on its top edge to unlatch it from the engine cover.
-
Remove the muffler cover.
-
-
-
Use a T30 Torx driver to remove the two screws securing the engine cover.
-
-
-
-
Lift the engine cover straight up to remove it.
-
-
-
Use a T30 Torx driver to remove the two screws securing the fan cover.
-
-
-
Pull the fan cover away from the motor assembly.
-
-
-
Reroute the two control cables through the opening on the fan cover.
-
Lay the cables into their slot on the clutch cover.
-
-
-
Use a T30 Torx driver to loosen, but not remove, the collar bolt securing the main shaft to the engine assembly.
-
-
-
Grip the engine assembly and pull to remove it from the main shaft.
-
-
-
Use a T30 Torx driver to remove the two screws securing the clutch cover.
-
-
-
Use a 1/2 inch socket to remove the two 12 mm-long bolts and four accompanying washers securing the clutch assembly.
-
Note that the larger washer goes underneath the clutch assembly and the small washer goes above.
-
Ensure that the clutch assembly is reinstalled arrow side up.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
