crwdns2915892:0crwdne2915892:0
Follow this guide to remove and replace the on/off switch on an EDCO Floor Stripper TS8 .75L (2017).
crwdns2942213:0crwdne2942213:0
-
-
Ensure the machine is unplugged.
-
Turn the power switch counterclockwise into the OFF position.
-
-
-
Use a Phillips screwdriver to remove the screw from the center of the red on/off knob.
-
-
-
Remove the black plastic cap from the center of the switch assembly.
-
-
-
Use a Phillips screwdriver to remove the two screws securing the yellow switch guide to the switch assembly.
-
-
-
Remove the yellow switch guide from the switch assembly.
-
Remove the black plastic spacer from underneath the yellow switch guide.
-
-
-
Use a Phillips screwdriver to remove the four screws securing the upper half of the switch housing to the lower half.
-
-
-
Lift the upper half of the switch housing off of the lower half."
-
-
-
Use a 3/8 inch socket to remove the bolt securing the power cord loom clamp to the switch bracket.
-
-
-
-
Remove the loom clamp from the power cable.
-
-
-
Use a socket to remove the four 11/32 inch nuts from the on/off switch bracket.
-
-
-
Lift the switch assembly off of the switch bracket.
-
-
-
Use a flathead screwdriver to remove the screw securing the two green ground wires to the switch housing.
-
-
-
Separate the green ground wires from each other and move them away from the switch housing.
-
-
-
Use a flathead screwdriver to loosen the two screws on the right side of the switch assembly securing the black and white wires from the power cord.
-
-
-
Remove the black wire from the switch.
-
-
-
Remove the white wire from the switch.
-
-
-
Use a 1-1/16 inch wrench or an adjustable wrench to loosen the power cord's strain relief fitting from the switch housing.
-
Once the fitting is loose enough to turn by hand, twist the power cord and fitting counterclockwise until it is fully unthreaded from the switch housing.
-
-
-
Remove the power cord from the on/off switch.
-
-
-
Use a flathead screwdriver to loosen the two screws securing the wiring harness's black and white wires to the switch.
-
-
-
Remove the black wire from the switch.
-
-
-
Remove the white wire from the switch.
-
-
-
Use a 1-1/16 inch wrench or an adjustable wrench to loosen the wiring harness cable's strain relief fitting from the switch housing.
-
Once the fitting is loose enough to turn by hand, twist the wiring harness cable and fitting counterclockwise until it is fully unthreaded from the switch housing.
-
-
-
Remove the on/off switch from the auxiliary cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
