crwdns2915892:0crwdne2915892:0
How to disassamble the Dyson V10's Motorhead for maintainance and spring-cleaning.
crwdns2942213:0crwdne2942213:0
-
-
Translucent cover before and after cleaning.
-
-
-
Remove red lid by releasing the clamps (yellow arrows) with a spudger to get access to more screws, that hold the translucent shield.
-
Remove Two Torx screws that hold the silver cover-plate on the opposite side of the motorhead that covers the translucent shield.
-
Remove the rotating brush by realeasing it with a coin.
-
-
-
-
Remove the five Torx screws (red), that hold the translucent shield.
-
Remove the single shorter Torx screw (yellow), that fixes the silver and the translucent shield.
-
-
-
Remove the silver shield by gently pulling into the directions of the red arrows. (This is the only tricky part of the whole procedure.)
-
-
-
After removal of the silver-shield the translucent shield can be removed easily. The black and white cables are attached with the black plug and can be reattached easily on reassambly.
-
-
-
After removal of the translucent shield, both the shield and the silver-skeleton that holds the rotating motorhead can be cleaned thoroughly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2947410:01crwdne2947410:0
Bonjour,
J'ai besoin d'acceder aux fiches electriques qui se connectent au tube, je n'y parviens pas, je découvre à l'instant votre tuto qui m'aurait bien aidé il y a deux jours...Merci
