crwdns2937539:0crwdnd2937539:0crwdne2937539:0
crwdns2942213:0crwdne2942213:0
-
-
Turn off and unplug the vacuum
-
-
-
Press the red release button and pull the canister up and away.
-
-
-
Locate the red dial at the back of the wand and turn counterclockwise to detach the wand.
-
-
-
-
Remove the four 15mm screws behind the power button using a Torx T15 screwdriver.
-
-
-
Use a spudger to push the two clamp tabs behind the power button towards the middle of the vacuum.
-
-
-
Detach the power box case from the body of the Dyson after both clamps have been pushed out.
-
Upon removal of this case, you will be able to see a red circular power button.
-
-
-
Gently pull the power button out of its slot as shown.
-
Detach the power button box from the two wires connecting it, and replace the faulty power button box with a functional one. The power button is the first black one.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0