crwdns2942213:0crwdne2942213:0
-
-
Remove the six 13 mm casing screws with the #0 Phillips screwdriver.
-
-
-
Separate the screwdriver casing halves with the plastic opening tool.
-
-
-
-
Slide the bit chuck assembly out from the casing half.
-
-
-
Apply a dab of grease to the end of the drill motor coupler.
-
-
-
Insert new bit chuck assembly into the drill casing.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0