Durofix RV332 Battery Replacement

crwdns2931653:01crwdne2931653:0 Battery




• Remove the six 13mm case screws with a #0 phillips screwdriver.
• Separate the screwdriver housing with a plastic opening tool.
• Remove battery casing half to expose screwdriver internals.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:02crwdne2931653:0



• Locate battery
• Remove battery, printed circuit board, LED, and motor assembly from screwdriver casing.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0
crwdns2931653:03crwdne2931653:0
• Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.
• Strip the ends of the wires attached to the printed circuit board 1/4 inch above the ends of the cut wires.
• Solder the new battery to the stripped wires attached to the printed circuit board.
• Wrap the newly soldered connections with electrical tape.
crwdns2913378:0crwdne2913378:0
crwdns2934285:0crwdne2934285:0
crwdns2934285:0crwdne2934285:0
crwdns2917038:0crwdne2917038:0
1024
crwdns2891542:0crwdne2891542:0 crwdns2934287:0crwdne2934287:0

crwdns2862417:0crwdne2862417:0

crwdns2935293:0crwdnd2935293:04crwdnd2935293:0crwdne2935293:0

Brennan Wade

crwdns2935283:002/21/14crwdne2935283:0

122 crwdns2915208:0crwdne2915208:0

crwdns2935295:0crwdne2935295:0

crwdns2918514:0crwdne2918514:0: 10

• 
• 
• 

crwdns2935301:07crwdne2935301:0

crwdns2915084:0crwdne2915084:0

Michigan Tech, Team 5-5, Lauer Spring 2014 crwdns2935289:0Michigan Tech, Team 5-5, Lauer Spring 2014crwdne2935289:0

MTU-LAUER-S14S5G5

crwdns2931471:03crwdne2931471:0

crwdns2935297:05crwdne2935297:0

crwdns2942557:0crwdne2942557:0

crwdns2942955:0crwdne2942955:0

crwdns2852917:0crwdne2852917:0