crwdns2915892:0crwdne2915892:0
Disassembling your Dremel 8200.
crwdns2942213:0crwdne2942213:0
-
-
Take off the screw cap at the top
-
-
-
-
The casing should just open right up and be easily accessible
-
-
-
You can remove the buttons except for the sliding one that adjusts the speed
-
-
-
Work your way down and take out each successive circuit board
-
The last thing to be out should be the sliding speed adjustment and the button for that should fall right out
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0
crwdns2944067:02crwdne2944067:0
It will be handy to have either a can of compressed air or an air directional nozzle on your compressor. Be careful of the circuits and small parts that can blow away. You'll be amazed how even with a maintenance schedule, how much dirt will be on the motor fins
How do you replace just the bearing in this assembly?
