crwdns2915892:0crwdne2915892:0
This guide is a complete, all-around guide to disassembling this model laptop. Use this guide to replace any of the parts in the laptop. Stop when you get to the part you want to replace and simply follow the guide backwards from where you stopped to reassemble your device.
crwdns2942213:0crwdne2942213:0
-
-
Remove the other 6 screws.
-
Remove the hard disk and the RAM slots.
-
-
-
This is the hard disk - Hitachi 500 GB
-
-
-
Ensure that the hard disk has been removed. Carefully detach the bottom cover.
-
-
-
Once the bottom cover is removed, your device should look like this.
-
-
-
Remove the 4 screws to detach the battery.
-
Remove all of the sticky tape.
-
Carefully disconnect the small power connector by using a tool to push the connector out through the small gap in the middle of the connector.
-
-
-
-
This is the Samsung 7.4V 45Wh battery.
-
Ensure that the battery is removed before continuing.
-
-
-
When the battery is removed, this is how it will look.
-
-
-
Remove the processor fan.
-
There are 2 screws holding it in place. Loosen and remove them.
-
-
-
Remove the processor heat sink.
-
3 screws hold this part in place. Loosen and remove them.
-
-
-
Disconnect the antenna cables from the WiFi card.
-
Remove the screw.
-
-
-
Remove the screw.
-
Lift the latch upwards to loosen the cable.
-
-
-
To remove the Motherboard, carefully disconnect the cables.
-
-
-
This is the Motherboard - there is a front and rear view.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:034crwdne2935229:0
crwdns2947412:030crwdne2947412:0
Hello,
Do you know where can i reset the Bios CMOS in that motherboard?
I think there are people who wants to know becose system upgrade is leading to bios ACPI Error.
Thanks for your help
No, I do not know where is a reset pin of BIOS.
Try to disconnect NVRAM battery.
Wait 15 minutes and reconnect again.
To reset BIOS this NP530U3, only disconnect all power supply (MAIN battery, CMOS battery and power source). And hold press POWER button for 1 min.
I try it but don't work, do you know another way to do this
manhique -
Hello,
I have seen many screens with model number LTN140AT21-XXX for this laptop. My laptop NP530u4b has a screen LTN140AT21-802. I would like to know if I can use a LTN140AT21-002 screen, or if only is good a screen with number LTN140AT21-8.
thanks for your help.
