crwdns2942213:0crwdne2942213:0
-
-
Unscrew these #1 Philips screws, and leave them in the plastic foot holders.
-
-
-
Remove the foot holders and place them on the side
-
-
-
-
Remove the four feet and place them on the side
-
-
-
Remove these #1 Philips screws, and leave them in their counterbores
-
-
-
Lift grey shell off and place to the side to reveal:
-
ADC and Logic board
-
Bluetooth module
-
Strain gauges
-
Battery holder
-
-
-
The ADC and Logic board contains:
-
Bluetooth module
-
Power button connector
-
Battery and sync button connector
-
Strain gauge wheatstone bridge connections
-
The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:015crwdne2935229:0
crwdns2947412:05crwdne2947412:0
Great stuff Pete, being able to fix the wifi board got me mucho street cred with " her indoors " and lots of other goodies that go along with that
Can I take out the battery box without removing the bottom?
No, you can't. You will have to follow this procedure completely.
Thank you! I was able to fix our 10 year old balance board.
the kids think I’m a roakstar, for now anyway.
is there schematics for the power pcb
?
