crwdns2915892:0crwdne2915892:0
This guide acts as a prerequisite for the guides following it. This will show you how to disassemble to phone enclosure in order to access the internal components of the device.
crwdns2942213:0crwdne2942213:0
-
-
Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.
-
-
-
Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.
-
-
-
Remove the rubber plug located near the camera by gently prying upward with your fingers.
-
Gently lift the camera shield after removal of the rubber plug.
-
-
-
-
Pry the remaining panel to loosen its contact to the phone using a spudger.
-
Slide the panel upward to remove it completely.
-
-
-
Slide the aerial upward to remove it.
-
-
-
Remove the four screws located at each corner of the device.
-
-
-
Gently lift and remove the front panel of the phone after removing the screws.
-
-
-
Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.
-
Gently pull the ribbon from the circuit.
-
Remove the now disconnected screen.
-
-
-
Remove the keyboard by slowly pulling it away from the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
crwdns2915084:0crwdne2915084:0
University of Maine, Team 1-13, Diaz Fall 2013 crwdns2935289:0University of Maine, Team 1-13, Diaz Fall 2013crwdne2935289:0
UMAINE-DIAZ-F13S1G13
crwdns2931471:03crwdne2931471:0
crwdns2935297:014crwdne2935297:0
