crwdns2942213:0crwdne2942213:0
-
-
Turn the camera off by pressing the small, square button embedded in the top rim of the camera.
-
Locate the battery hatch on the bottom-right side of the camera and slide it outwards to open.
-
In the compartment, move the small notch and push down on the battery to remove it.
-
-
-
Remove the eight screws around the sides and bottom of the camera using a Phillips #00 screwdriver.
-
-
-
Using the spudger, gently pry the rear panel away from the left side.
-
-
-
-
Using the Phillips #00 screwdriver, remove the eight black screws connecting the green keypad chip to the rear panel.
-
-
-
Separate the rear panel from the rest of the camera.
-
-
-
Using the Phillips #00 screwdriver, remove the 3 screws located across the top of the camera.
-
Separate the black plastic panel from the camera. The camera button will be attached, so be gentle.
-
-
-
Carefully pull off the side covers wrapped around the camera.
-
-
-
Using the spudger, gently lift off the front cover of the camera.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 27-95, Amido Spring 2010 crwdns2935289:0Cal Poly, Team 27-95, Amido Spring 2010crwdne2935289:0
CPSU-AMIDO-S10S27G95
crwdns2931471:04crwdne2931471:0
crwdns2935297:04crwdne2935297:0
