crwdns2942213:0crwdne2942213:0
-
-
Place your thumb on the battery cover and push left towards the arrow.
-
-
-
Remove the batteries from the camera.
-
-
-
Remove four 3 mm screws on the right side of the camera using a Phillips #1 screwdriver.
-
-
-
Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.
-
-
-
Under the screen, locate the black plastic strip that sits above the white plastic strip.
-
-
-
-
Pull both sides of the black piece upward-about a mm.
-
Once the piece is lifted carefully slide the screen out of the slot.
-
-
-
Unscrew and remove the four (6 mm) screws on the inside casing.
-
-
-
Pull the inner casing off of the camera.
-
-
-
Unscrew and remove the four (4mm) screws from the logic board.
-
-
-
Use a spudger to pry up all four sides of the logic board and slide it out of the camera.
-
-
-
Unscrew and remove the two (5mm) screws from the logic board to the far left.
-
-
-
Locate the black plastic piece behind the lens.
-
-
-
Similar to the LCD screen, pull the black piece up about a mm and it will release the lens.
-
Once the black piece is lifted slide the ribbon out to release the lens.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 3-3, Johann Summer 2010 crwdns2935289:0Cal Poly, Team 3-3, Johann Summer 2010crwdne2935289:0
CPSU-JOHANN-R10S3G3
crwdns2931471:02crwdne2931471:0
crwdns2935297:07crwdne2935297:0
