crwdns2915892:0crwdne2915892:0
Replacing the PCB or logic board of the phone.
crwdns2942213:0crwdne2942213:0
-
-
Apply pressure on the cover while simultaneously sliding the cover downward.
-
Remove the back battery cover.
-
-
-
Insert the spudger between the base of the phone and the phone battery.
-
Position the phone so that the battery won't fall out of the phone.
-
Carefully lift the battery out of the phone.
-
-
-
-
Use a Phillips #00 screwdriver or your fingers to remove the rubber tabs at top back of the phone.
-
-
-
Remove four 5mm screws from the back of the phone using a T6 Torx screwdriver:
-
2 screws at the bottom
-
2 screws at the top
-
-
-
Insert the spudger in tabs between the outer casing and the inside frame.
-
Slide the spudger upwards.
-
-
-
The phone should now be in two different sections.
-
1) The rear case of the phone.
-
2) The motherboard and the rest of the phone.
-
-
-
Use the spudger to lift off the yellow clip near the top right corner of the motherboard.
-
-
-
Use the spudger to lift the motherboard out of the base of the phone.
-
Remove the motherboard from the base of the phone.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 1-14, Amido Winter 2011 crwdns2935289:0Cal Poly, Team 1-14, Amido Winter 2011crwdne2935289:0
CPSU-AMIDO-W11S1G14
crwdns2931471:05crwdne2931471:0
crwdns2935297:016crwdne2935297:0
