crwdns2915892:0crwdne2915892:0
Removing the stand from the rest of the monitor allows you to access and replace parts inside the display assembly.
Before beginning this guide, prepare a clean, flat surface to use as a workstation. Avoid working over carpeting, as small screws are used and, if dropped, may be lost in the carpet.
crwdns2942213:0crwdne2942213:0
-
-
Place the monitor face down on a clean, flat surface.
-
-
-
Firmly remove the back panel of the stand by pulling it up and away from the monitor.
-
-
-
-
Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.
-
-
-
Firmly grasp the stand enclosure with your hand and slide it to base of stand.
-
-
-
Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.
-
-
-
Lift the the stand straight up to remove it.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.