crwdns2915892:0crwdne2915892:0
The speaker is attached to the circuit board with two wires and is glued onto the front case. After the speaker is removed the new speaker will need to be re-glued and re-soldered into place.
crwdns2942213:0crwdne2942213:0
-
-
First, apply pressure with your thumb on the top of the battery cover.
-
Next, pull down on the cover until it begins to slide.
-
-
-
Finally, once the cover is completely off, pry up the old batteries with your finger or a strong, skinny tool (i.e. spudger).
-
-
-
Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
-
-
-
-
Detach back part of the case by gently lifting up.
-
-
-
Remove the circuit board from the front part of the radio case.
-
Desolder the red and black speaker wires from the motherboard.
-
-
-
Scrape off the glue on the outer lining of the speaker using the metal spudger.
-
-
-
Pry the speaker from the case using the metal spudger.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:03crwdne2935229:0