crwdns2931315:0crwdnd2931315:0crwdne2931315:0
crwdns2942213:0crwdne2942213:0
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Using the spudger, create space between the speaker covers and then remove.
-
On the underside of the device, remove the rubber stand with the BeatsPill logo on it.
-
Using an ESD-safe Phillips #0 screwdriver, remove the four screws that were underneath the rubber stand.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Remove the two screws with a Phillips #0 screwdriver.
-
Slowly remove the center band and two clip rings until the adhesive separates. Sit to the side the clip rings and the center band
-
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Use the spudger to pry the device apart along its seam, starting in the middle.
-
Open the device to separate the front and back panels.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Carefully remove the yellow, red, black, and white wires from the motherboard.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Carefully remove the black and red NFC sensor wires.
-
-
crwdns2935201:0crwdne2935201:0 crwdns2935203:0crwdne2935203:0
-
Carefully remove the control cables (4 black, 1 red).
-
crwdns2935221:0crwdne2935221:0
crwdns2935229:05crwdne2935229:0