crwdns2942213:0crwdne2942213:0
-
-
First: Eye Camera
-
Remove initial frame (crack off)
-
-
-
Remove cover to get to the PCB underneath
-
-
-
Remove PCB from the base plastic piece.
-
-
-
Break base plastic piece. Cutters work well. Be careful not to snip the wire attached to the PCB.
-
-
-
Black mold (from 3D printer) piece attaches to the PCB with 4 screws.
-
-
-
Completed assembly of the eye camera.
-
-
-
Back of pupil camera is glued on. Remove with flat-head.
-
-
-
Remove the black frame on the front of the pupil camera.
-
-
-
Once frame is taken off the front, two screws need to be removed.
-
-
-
-
Front housing comes off once the screws are removed from the frame.
-
Twist out the silver microphone.
-
-
-
Pull off bottom stand until it breaks off.
-
-
-
Remove rubber/plastic piece from the bottom
-
-
-
Remove four screws from under the plastic tape (removed from last step).
-
-
-
Separate the metal frame from the plastic assembly.
-
Avoid the cables
-
-
-
Take out PCB from the plastic housing.
-
-
-
Remove the rest of the black plastic housing.
-
-
-
Continue removing the black plastic housing surrounding the inner PCB.
-
-
-
PCB removed from the black plastic housing.
-
-
-
Autofocus assembly.
-
Remove two screws from the bottom of the auto-focus PCB.
-
-
-
Take out the IR filter by using a scalpel for pulling out the lens tape.
-
-
-
Comparison photos of completed autofocus assembly vs in-progress autofocus assembly
-
-
-
IR LEDs replaced by SMD LED
-
Soldering required here (at bottom of LED to remove).
-
-
-
SMD LED info: Thick black line is near the positive side of the LED
-
Dark side (dot) is positive side on LED.
-
-
-
Completed assembly.
-
Sugru used for nose/head rest
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0
