crwdns2915892:0crwdne2915892:0
If the DC power connector is broken this guide will teach you how to remove the broken component for replacement.
crwdns2942213:0crwdne2942213:0
-
-
Remove the four 8mm Phillips #0 screws located on the back panel.
-
-
-
Remove the back panel to expose the motherboard.
-
-
-
-
Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
-
-
-
Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
-
-
-
Desolder the back of the motherboard where the power connector is located.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947410:01crwdne2947410:0
Later? I cant see to other