DigiTech RP70 LED Light Replacement
crwdns2959932:0crwdnd2959932:0Elijah Smithcrwdnd2959932:0crwdnd2959932:0crwdnd2959932:03crwdnd2959932:0crwdne2959932:0
crwdns2959936:0Sun 2, 2019crwdne2959936:0
crwdns2869540:0crwdne2869540:0: 645
crwdns2959988:0crwdne2959988:0
- crwdns2959990:0crwdne2959990:0
- 0
- crwdns2959992:0crwdne2959992:0
- 7
- crwdns2959994:0crwdne2959994:0
- 52
- crwdns2959996:0crwdne2959996:0
- 645
crwdns2955950:0crwdne2955950:0: 0
crwdns2959998:0crwdne2959998:0
crwdns2960000:0crwdne2960000:0crwdns2959984:0crwdne2959984:0: 0 1
crwdns2959956:0crwdne2959956:0
crwdns2959968:01crwdne2959968:0
crwdns2959986:0crwdne2959986:0: 0 1
crwdns2959958:0crwdne2959958:0
crwdns2959976:01crwdne2959976:0
crwdns2915892:0crwdne2915892:0
crwdns2959928:0crwdne2959928:0 ↓If the LED light is broken, or dead, this guide will teach you how to remove the broken component for replacement.
crwdns2959930:0crwdne2959930:0
crwdns2943215:0crwdne2943215:0
-
-
-
Remove the four 8mm Phillips #0 screws located on the back panel.
crwdns2952109:0crwdne2952109:0
-
-
-
Remove the back panel to expose the motherboard.
-
-
-
Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
-
-
-
Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
-
-
-
-
-
-
Desolder the back of the motherboard where the LED light is located.
-
-
To reassemble your device, follow these instructions in reverse order.
crwdns2935287:0crwdne2935287:0
Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 crwdns2935289:0Appalachian State University, Team S2-G2, Menagarishvili Fall 2018crwdne2935289:0
APSU-MENAGARISHVILI-F18S2G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:072crwdne2935297:0
