crwdns2942213:0crwdne2942213:0
-
-
Unscrew the 6 Torx T5 screws from the back of the device
-
-
-
Use a spudger to lift up the screen assembly ribbon cable flap, then remove the ribbon cable.
-
Screen Information: Model AM0310R-04 Lot # NHT18080052
-
-
-
-
Using a spudger, unplug the Charging Port connector from the motherboard.
-
-
-
Remove the 2 silver Torx T5 screws holding the charging port down.
-
-
-
Remove the Charging Port Assembly from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2947412:05crwdne2947412:0
Where can the part be purchased?
I'm not sure if there is a replacement charging port assembly available online. If you're good at microsoldering, you could replace the surface mount micro USB port on the assembly.
Andrew S -
where can the part be purchased?
would a cell phone repair shop be able to do this?
If they are comfortable with it. Tell them it will probably require microsoldering.
Andrew S -
