crwdns2915892:0crwdne2915892:0
This guide shows how to remove the back support assembly for the Dewalt Nailers DCN680D1 2018. The support needs to be removed in order to replace the driver or the control module.
crwdns2942213:0crwdne2942213:0
-
-
Remove the following screws securing the outer housing:
-
Twelve T10 screws
-
One 2.5 mm hex screw
-
-
-
Lift and remove the right housing from the device.
-
-
-
Remove the lock button from its recess.
-
-
-
-
Slide the battery connector out of its recess.
-
-
-
Remove the switch board, switch, and spring from its housing recess.
-
-
-
Carefully flip the device over.
-
Remove the left housing from the device.
-
-
-
Carefully remove the release button from the device.
-
Remove the button spring from the device.
-
-
-
Use a T20 driver to remove the two screws (one on either side) securing the back support .
-
-
-
Loosen the two solenoid wires from the back support.
-
-
-
Pull the back support straight out of the device.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.