crwdns2915892:0crwdne2915892:0
Use this guide to remove or replace the profile from within the return system assembly in a Dewalt DCN21PL 2018 Nailer.
crwdns2942213:0crwdne2942213:0
-
-
Before you begin the repair, remove the battery from the device.
-
-
-
Use the provided 3.5 mm hex key to remove the two return system bolts on either side of the nailer.
-
-
-
Pull the end cap away from the nailer to remove the return system assembly.
-
-
-
-
Use your thumbs to pull the spring bumpers just far enough away from the rail clips so they aren't touching.
-
-
-
Use a large flathead screwdriver to slide the rail clip off of the tip of the rail.
-
Remove the rail clip.
-
-
-
Firmly grasp the spring bumper. Pull up while twisting to remove it from the rail.
-
Remove the spring bumper and accompanying washer.
-
Repeat Steps 4-6 for the other rail.
-
-
-
Pull both springs directly up off the rails to remove.
-
-
-
With the rails clear, the profile can now slide off. Pull the profile off the rails to remove.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0