crwdns2915892:0crwdne2915892:0
Use this guide to open the upper case to access internal components for repair or replacement in a Dewalt DWFP55126 Air Compressor.
Make sure to completely depressurize the air compressor tank before performing any repairs.
crwdns2942213:0crwdne2942213:0
-
-
Use a long-shank T10 driver to remove the manifold cover screw.
-
Lift the cover directly up off of the gauges to remove.
-
-
-
Use a T20 driver to remove the two handle screws, one on each side.
-
-
-
-
Grab the handle like you would if you were to pick the compressor up. Pull up and push forward away from the gauges at the same time to rotate the handle up off the case.
-
Lift the handle off to remove.
-
-
-
Remove the following four screws:
-
Three 20 mm-long T20 screws.
-
One 20 mm-long Phillips #1 screw.
-
-
-
Firmly push the top case off of the four tabs to detach.
-
-
-
Carefully pull the half of the case that is opposite the manifold away from the tank.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
