crwdns2915892:0crwdne2915892:0
This guide shows how to detach the wireless WLAN card wires. This is not a replacement guide for the wires or the card.
crwdns2942213:0crwdne2942213:0
-
-
Turn the device on its screen.
-
Remove the ten 4mm screws using a T8 Torx screwdriver.
-
-
-
Gently flip out support feet located near the bottom of device.
-
-
-
Gently lift the back cover off the device. The back cover should come off easily.
-
-
-
Use the opening tool's angled edge to lift the clasps securing the screen and motherboard cables.
-
-
-
-
Disconnect the screen and copper colored motherboard cables and tuck them under the device to prevent future hassle.
-
-
-
Remove the two black 3mm screws from the internal cover with a Phillips 00 screwdriver.
-
Remove the internal cover.
-
-
-
Disconnect the black camera cable and pull it back to prevent future hassle.
-
-
-
Use the angled edge of the plastic opening tool to lift the clasp securing the touch control board cable.
-
Disconnect the silver and blue touch control board cable.
-
-
-
Remove the two silver 3mm screws holding the touch control board in place with a Phillips 00 screwdriver.
-
Remove the touch control board.
-
-
-
Use the plastic opening tool's angled edge to remove the black and white wires connected to the wireless WLAN card.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
Cal Poly, Team 6-29, Amido Winter 2015 crwdns2935289:0Cal Poly, Team 6-29, Amido Winter 2015crwdne2935289:0
CPSU-AMIDO-W15S6G29
crwdns2931471:04crwdne2931471:0
crwdns2935297:016crwdne2935297:0
