crwdns2915892:0crwdne2915892:0
If the laptop will not connect to wireless internet, you may need a new wireless card.
crwdns2942213:0crwdne2942213:0
-
-
Turn the laptop upside down.
-
Use a T5 Torx Screwdriver to remove the ten 3 mm long screws from the perimeter of the back of the laptop.
-
-
-
Open up the information panel door (on the middle of the back side).
-
While holding the door open, use a Phillips #00 Screwdriver to remove the two 10 mm long screws.
-
-
-
-
Carefully lift the 2 corners of the back panel close to the hinge upwards, to release the whole panel.
-
-
-
With a Philips #00 Screwdriver bit, remove one 4 mm long black screw located by the antenna connections on the wireless card.
-
Set the screw and metal holder aside.
-
-
-
Gently lift up each of the antennas (3) to disconnect them from the wireless card.
-
-
-
With the antennas disconnected, gently pull the wireless card out at the angle it sits at.
-
The wireless card has been successfully removed!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:04crwdne2935229:0