crwdns2915892:0crwdne2915892:0
Use this guide to remove or replace speakers in your Dell XPS 13 9365 2-in-1 laptop. The speakers in this laptop are embedded on the left and right sides and can be accessed by removing the base cover.
crwdns2942213:0crwdne2942213:0
-
-
Use a Torx T4 screwdriver to remove the eight screws (M2x3) that secure the base cover to the palm-rest assembly.
-
-
-
Use your fingertips to lift the system badge open and reveal the single case screw.
-
Use a Phillips #000 screwdriver to remove the screw (M1.6x4) that secures the base cover to the palm-rest assembly.
-
-
-
Starting from the front corner of the computer, pry up the base cover using a spudger and lift the base cover off the palm-rest assembly.
-
-
-
Disconnect the battery cable from the system board.
-
-
-
-
Use a Phillips #000 screwdriver to remove the two screws (M1.6x4) that secure the battery to the palm-rest assembly.
-
-
-
Use a Phillips #000 screwdriver to remove the six screws (M2x3) that secure the battery to the palm-rest assembly.
-
-
-
Lift the battery off the palm-rest assembly.
-
-
-
Peel off the tape securing the speaker cable to the system board.
-
-
-
Disconnect the speaker cable from the motherboard.
-
-
-
Note the speaker-cable routing and peel off the tape that secures the speaker cable to the system board.
-
-
-
Use a Phillips #000 screwdriver to remove the four screws (M2x2) that secure the speakers to the palm-rest assembly.
-
-
-
Lift the speakers, along with its cables, off the palm-rest assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
University of Alabama, Team 3-4, Bedsole Spring 2022 crwdns2935289:0University of Alabama, Team 3-4, Bedsole Spring 2022crwdne2935289:0
UA-BEDSOLE-S22S3G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
