crwdns2915892:0crwdne2915892:0
Use this guide to remove or replace this display assembly (screen) on your Dell XPS 13 9365 2-in-1 laptop. The display assembly on this laptop refers to the entire upper portion of the laptop, which houses the screen display.
crwdns2942213:0crwdne2942213:0
-
-
Use a Torx T4 screwdriver to remove the eight screws (M2x3) that secure the base cover to the palm-rest assembly.
-
-
-
Use your fingertips to lift the system badge open and reveal the single case screw.
-
Use a Phillips #000 screwdriver to remove the screw (M1.6x4) that secures the base cover to the palm-rest assembly.
-
-
-
Starting from the front corner of the computer, pry up the base cover using a spudger and lift the base cover off the palm-rest assembly.
-
-
-
Disconnect the battery cable from the system board.
-
-
-
Use a Phillips #000 screwdriver to remove the two screws (M1.6x4) that secure the battery to the palm-rest assembly.
-
-
-
Use a Phillips #000 screwdriver to remove the six screws (M2x3) that secure the battery to the palm-rest assembly.
-
-
-
-
Lift the battery off the palm-rest assembly.
-
-
-
Use a Phillips #000 screwdriver to remove the screw (M1.6x2.5) that secures the wireless-card bracket to the motherboard.
-
-
-
Lift the wireless-card bracket off the wireless card.
-
-
-
Use a pair of nylon tipped tweezers to gently disconnect the antenna cables from the wireless card.
-
-
-
Peel off the tape that secures the display cable to the M.2 solid-state drive heatsink.
-
-
-
Use a Phillips #000 screwdriver to remove the two screws (M1.6x2.5) that secure the display cable bracket to the motherboard.
-
Lift the display cable bracket off the display cable.
-
-
-
Use the pull tab to disconnect the display cable from the motherboard.
-
-
-
Disconnect the touch-screen cable from the system board (labeled "TS").
-
-
-
Disconnect the camera cable from the system board.
-
-
-
Open the palm-rest assembly fully and place the display assembly and palm-rest assembly face down.
-
Use a Phillips #000 screwdriver to remove the six screws (M2.5x3.5) that secure the display hinges to the palm-rest assembly. There are three on each side.
-
-
-
Lift the display assembly off the palm-rest assembly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
University of Alabama, Team 3-4, Bedsole Spring 2022 crwdns2935289:0University of Alabama, Team 3-4, Bedsole Spring 2022crwdne2935289:0
UA-BEDSOLE-S22S3G4
crwdns2931471:03crwdne2931471:0
crwdns2935297:03crwdne2935297:0
