crwdns2915892:0crwdne2915892:0
Batteries slowly lose their ability to hold charge over time. If your battery will not charge or hold a charge, please refer to the Troubleshooting Page. If the problem persists, replace the battery by following the steps below. Make sure your laptop is turned off before starting this guide.
crwdns2942213:0crwdne2942213:0
-
-
Flip the laptop over so the vents are facing you.
-
Remove the six 5.0 mm Phillips #1 screws using the magnetic driver.
-
Remove the two 5.0 mm Phillips #1 screws on the back side of the laptop.
-
-
-
Slide out the SD and MicroSD holders.
-
-
-
Slide the plastic opening tool around the perimeter of the laptop until the cover pops off.
-
Pull the back cover off.
-
-
-
-
Remove the three black 3.9 mm Phillips #1 screws holding the battery in place.
-
-
-
Flip up the clip of the ribbon connector.
-
Pull the strip out to disconnect the battery.
-
-
-
Replace with the new battery.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.