crwdns2915892:0crwdne2915892:0
In this guide, we will show you how to remove and replace the VGA Board.
crwdns2942213:0crwdne2942213:0
-
-
Slide the left and the right battery release latches to the unlock position.
-
-
-
Slide the battery and remove it from the computer.
-
-
-
Press the keyboard down. Pry the keyboard with the use of a flat-head screwdriver towards the display to reveal the first keyboard retainer.
-
-
-
Pry up the second keyboard retainer.
-
-
-
Pry up the third keyboard retainer.
-
-
-
Pry up the fourth keyboard retainer.
-
-
-
Pull up the keyboard from the palm rest.
-
-
-
Release the latch on the system board connector, then disconnect the keyboard cable.
-
-
-
Loosen the screw that secures the memory door.
-
-
-
Pry up the memory door near the screw hole, lift and remove it.
-
-
-
Remove the screw that secures the optical drive to the computer.
-
-
-
Gently pry the optical drive out of the computer.
-
-
-
Remove the screws that secure the optical drive bracket.
-
-
-
-
Remove the optical drive bracket from the optical drive module.
-
-
-
Remove the screws in the battery compartment.
-
-
-
Remove the screws in the optical drive compartment.
-
-
-
Remove the rubber from the bottom base on the right side.
-
-
-
Remove the rubber from the bottom base on the left side.
-
-
-
Remove all the screws from the bottom base.
-
-
-
Flip the computer around and remove the screws that secures the palm rest.
-
-
-
Release the latches on the system board connector, then disconnect the touch pad cable and the finger printer cable.
-
-
-
Release the latch on the system board connector and then disconnect the power button cable.
-
-
-
Release the latch on the system board connector and then disconnect the hot key cable.
-
-
-
Pry up the right side of the palm rest.
-
-
-
Pry up the left side of the palm rest.
-
-
-
Pry up the sides of the palm rest and remove it from the computer.
-
-
-
Remove the screws that secure the hinge cover.
-
-
-
Press down on the hooks highlighted in the image.
-
-
-
Flip the computer around and remove the hinge cover from the side.
-
-
-
Remove the screws that secure the display hinge.
-
-
-
Loosen the screw that secures the low-voltage differential signaling (LVDS) cable.
-
-
-
Disconnect the LVDS cable from the system board.
-
-
-
Disconnect the wireless local area network (WLAN) antenna cable.
-
-
-
Remove the screws that secure the left hinge.
-
-
-
Remove the screws that secure the right hinge.
-
-
-
Lift the display assembly and remove it from the computer.
-
-
-
Release the latch on the system board and then disconnect the VGA cable.
-
-
-
Remove the screw that secures the VGA board.
-
-
-
Remove the VGA board from the chassis.
-
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0