crwdns2915892:0crwdne2915892:0
If your speakers seem to be not in the best condition or broken entirely, use this guide to help change out your speakers. You will need a Phillips #0 screwdriver, a plastic opening tool, and tweezers.
crwdns2942213:0crwdne2942213:0
-
-
Place the device flat on its screen.
-
Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
-
Take the segment off and place it to the side.
-
-
-
Using the plastic opening tool, lift off the entire back screen of the tablet.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect the no-fuss ribbon cable connector.
-
Remove the battery by gently lifting it out of the device.
-
-
-
Remove three 4mm Phillips #0 screws.
-
-
-
Gently lift up the black covered wire and place it on the side, so that it is not in the way of the procedure.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
When encountering a zero insertion force connector, the best way it to carefully use tweezers to flip up the white locking flap securing the blue-tipped ribbon cable.
-
Then, gently use the tweezers to pull out the blue-tipped ribbon cable from the unlatched connector.
-
-
-
-
Use two fingers and gently pull the SD card breakout board from its space.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
There are five ribbon cables in a row that must be disconnected.
-
Using the tweezers, carefully pull out the first cable straight out of the no-fuss ribbon cable connector.
-
-
-
Using the tweezers, carefully pull out the cable straight out of the no-fuss ribbon cable connector.
-
-
-
When dealing with a zero insertion force connector, the best way it to carefully use a tweezer to flip up the white locking flap holding the blue-tipped ribbon cable.
-
Then, gently remove the ribbon cable from the socket.
-
-
-
When dealing with a zero insertion force connector, the best way it to carefully use a tweezer to flip up the white locking flap holding the blue tip wire.
-
Then gently remove the wire from the socket.
-
-
-
Carefully remove the adhesive tapes using the tweezers.
-
-
-
Using the tweezers, carefully flip up the locking tab on the Zero Insertion Force connector.
-
Then, gently disconnect the orange ribbon cable.
-
-
-
After removing all the adhesive strips, gently lift up the sensor board as to not bend it.
-
-
-
When dealing with a zero insertion force connector, the best way it to carefully use a tweezer to flip up the white locking flap holding the orange ribbon cable.
-
Once the white tab is lifted, use the tweezer to carefully pull out the orange ribbon cable.
-
-
-
Using your fingers, wiggle the speaker until it comes free from the device. Carefully remove it from the tablet.
-
-
-
Using your fingers, wiggle the other speaker until it comes free. Carefully remove it from the tablet.
-
-
-
Carefully pull out the connected speakers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0