crwdns2915892:0crwdne2915892:0
The steps in this guide will require a JIS #0 screw driver to remove 6 screws with a head size of approximately 4.36mm and length of 3.63mm.
crwdns2942213:0crwdne2942213:0
-
-
With the laptop closed and the bottom side facing up, slide the two battery latches towards the sides of the laptop.
-
-
-
Grasp the battery from the top and pull upward.
-
-
-
Remove the ten 8.6 mm JIS #0 screws.
-
-
-
-
Place fingers underneath cover and pull off the cover.
-
-
-
Pry off the plastic keyboard trim. It is easiest to start at the bottom of the keyboard.
-
-
-
Remove the six 3.63 mm JIS #0 screws holding the keyboard in place.
-
-
-
Lift the keypad up from the bottom.
-
Rest the keypad on the LCD screen for easy access during the next step.
-
-
-
Peel back the tape holding the ribbon connector.
-
Disconnect the ribbon and the keyboard will be free from the laptop.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2915084:0crwdne2915084:0
IUPUI, Team S2-G2, Baechle Fall 2018 crwdns2935289:0IUPUI, Team S2-G2, Baechle Fall 2018crwdne2935289:0
IUPUI-BAECHLE-F18S2G2
crwdns2931471:03crwdne2931471:0
crwdns2935297:08crwdne2935297:0
crwdns2947410:01crwdne2947410:0
Hello,
Nice instructions, could someone please tell me what are the other conector/ribbions used for in this dell e6520 under the keyboard ? any help will most appreciated.
Thanks in advance
