crwdns2915892:0crwdne2915892:0
This is an easy component to replace and only need a screwdriver to complete. This may be replaced if you get a blue screen before the laptop starts.
crwdns2942213:0crwdne2942213:0
-
-
Place the laptop upside down on a flat, stable surface.
-
-
-
Remove the 3mm screw in the location shown, using a Phillips #1 screwdriver.
-
-
-
Remove the panel from the sides and pull it out at an angle towards you.
-
-
-
-
Remove the five 3mm screws on the battery with a Torx (T8) screwdriver in the locations shown.
-
-
crwdns2935267:0crwdne2935267:0Tweezers$4.99
-
Disconnect the power cord from the battery by using a pair of tweezers, your fingers, or the opening tools from the iFixit pro tech tool kit.
-
Pinch the clips on the left and right side while pulling on the cord at the same time.
-
-
-
Pull the battery towards you.
-
Make sure to pull at an upward angle.
-
-
-
Remove the 3mm screw on the back using a Phillips #1 screwdriver.
-
-
-
Remove the panel by lifting up the side towards you
-
-
-
Release the two clips on the left and right side, by pushing outward on the side towards you.
-
The RAM strip will extend out. Pull towards you at a slight angle.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.