crwdns2915892:0crwdne2915892:0
You will need to purchase a keyboard in order to proceed with the replacement.
crwdns2942213:0crwdne2942213:0
-
-
Close the display and turn over the computer.
-
-
-
Use a J0 bit tipped screwdriver to unscrew the one 6 mm Phillips screw on the RAM cover.
-
-
-
Lightly lift the RAM cover up and at an angle, away from the computer.
-
-
-
Use your fingers to carefully pull the securing clips on the RAM away from each other.
-
-
-
-
Remove the popped up RAM by pulling it away from the connection.
-
-
-
Lift the plastic yellow flap on the system board.
-
Use the J0 Bit screwdriver to remove the one 6 mm Phillips screw in center of the system board that is connected to the keyboard.
-
-
-
Flip over the computer and open the display.
-
-
-
Insert a spudger next to the plastic indents located at the top of the keyboard and gently pry to release the securing clips.
-
Lift the keyboard off of the computer.
-
-
-
Flip the keyboard over onto the palm-rest assembly.
-
-
-
Flip the little black securing bar near the base of the ribbon with a spudger to release the ribbon from the computer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
crwdns2935221:0crwdne2935221:0
crwdns2935229:02crwdne2935229:0