crwdns2915892:0crwdne2915892:0
How to remove and replace the Base Cover.
crwdns2942213:0crwdne2942213:0
-
-
Close the display, and turn the computer over.
-
-
-
Remove the eight screws that secure the base cover to the palm-rest assembly.
-
-
-
Remove the two screws that secure the base cover to the palm-rest assembly.
-
-
-
Remove the three screws that secure the base cover to the palm-rest assembly.
-
-
-
Turn the computer over, and open the display.
-
-
-
Remove the three screws that secure the base cover to the palm-rest assembly.
-
-
-
Open the latch, and disconnect the optical-drive cable from the system board.
-
-
-
-
Close the display, and turn the computer over
-
-
-
Using a plastic scribe, pry the base cover off the palm-rest assembly.
-
-
-
Lift the base cover off the palm-rest assembly.
-
-
-
Release the optical-drive interposer from the tabs, and remove it from the base cover.
-
-
-
Slide the optical-drive interposer into the tabs on the NEW base cover and snap it into place.
-
-
-
Place the base cover on the palm-rest assembly and route the optical-drive cable through the slot on the palm-rest assembly.
-
-
-
Slide the tabs on the base cover into the slots on the palm-rest assembly, and snap the base cover into place.
-
-
-
Slide the optical-drive cable into the connector on the system board and press down the latch to secure the cable.
-
-
-
Replace the three screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Close the display, and turn the computer over.
-
-
-
Replace the three screws (M2x2) that secure the base cover to the palm-rest assembly.
-
-
-
Replace the two screws (M2x5) that secure the base cover to the palm-rest assembly.
-
-
-
Replace the eight screws that secure the base cover to the palm-rest assembly.
-
crwdns2935221:0crwdne2935221:0
crwdns2935227:0crwdne2935227:0
crwdns2915084:0crwdne2915084:0
RampUP America, Inc. crwdns2935289:0RampUP America, Inc.crwdne2935289:0
Community
crwdns2931471:042crwdne2931471:0
crwdns2935297:01,985crwdne2935297:0
