crwdns2915892:0crwdne2915892:0
In this guide, we will be showing you how to remove and replace the Display Assembly.
crwdns2942213:0crwdne2942213:0
-
-
Remove the two screws that secure the display panel to the chassis.
-
-
-
Turn the computer over and open the display as far as possible.
-
-
-
Make a note of the routing of the Mini-Card antenna cables and the display cables. Remove the cables from the routing guides.
-
-
-
-
Remove the two screws (one on each side) that secure the display assembly to the computer base.
-
-
-
Make a note of the cable routing and disconnect the display cable and the wireless card antenna cables from the connectors on the Mini-Card.
-
-
-
Lift and remove the display assembly off the computer base.
-
-
-
Place the NEW display assembly in position and replace the two screws (one on each side) that secure the display assembly to the computer base.
-
-
-
Route the Mini-Card antenna cables and the display cable through the slot on the computer base.
-
-
-
Connect the display cable to the connector on the system board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.